Riso ComColor 9050 Basic Manual page 23

Preparing the Stacking Tray
Set up the stacking tray as follows. Depending on the size
or type of paper for printing, also adjust the paper
arranger at this time.
●
The RISO auto-control stacking tray is shown in this
illustration.
When using the wide stacking tray, manually adjust the
paper guides' (side and end) positions to fit the paper size.
1
Open the stacking tray until it stops.
2
Lift the paper guides (side) to stand them upright.
3
Adjust the paper arranger.
Normally, the paper arranger should be extended when
printing on paper that is B4 size or smaller. How paper is
stacked after printing varies depending on stiffness and
other factors. Adjust the arranger as needed.
Preparations for Use >> Paper and Originals
4
Lift the paper guide (end) to stand it upright.
Fold all paper guides when printing on paper larger
than 320 × 432 mm (12
Closing the Stacking Tray
The wide stacking tray cannot be closed.
1
After confirming that there are no printouts in the
stacking tray, press the paper guides open button.
The paper guides (side and end) now move into position for
storage.
2
Lower the paper guide (end) toward the stacking
tray to fold it up.
ComColor Series Basic Guide 02
1
/ " × 17").
2
1