Riso ComColor 9050 Basic Manual page 22

Adding or Switching Paper in the Standard
Tray
Press the standard tray descent button when loading additional
sheets or when switching paper. Note that the standard tray is
automatically lowered when all paper is removed.
1
Press the standard tray descent button to lower the
standard tray.
Hold the button until the tray reaches the desired position.
2
Load additional paper, or switch the loaded paper.
About the Paper Feed Pressure for the Standard Tray
You can use the paper feed pressure adjustment lever to adjust the paper
feed pressure to suit the paper that you have set. The lever can be set to
" (NORMAL)" or "
When you change the position of the paper feed pressure adjustment lever,
also change [Paper feed] in [Change] of the operation panel's [Feed Tray].
(See p. 39.)
Paper Feed Pressure Adjustment Lever and Paper
The supported paper textures are as follows.
Lever Position
(NORMAL)
(CARD)
0
(CARD)" in accordance with the paper texture.
Paper Texture
Standard or thin paper
Thick paper or special
paper
Closing the Standard Tray
1
Remove the loaded paper.
Make sure the machine is on.
2
Close the standard tray.
Make sure the standard tray is all the way down
before closing it.
Supported Printing Paper
• Standard paper, recycled paper
• High-quality paper
• Drawing paper
• Postcards
If the machine's paper feeding is poor, set the lever position to [NORMAL].
• Commercially available copy paper,
and similar media
• Envelopes
ComColor Series Basic Guide 02