To Exit Programming Mode; Data Fields - Honeywell Lynx Plus Programming Manual

To Initialize Download ID and Subscriber Account Number for Downloading:
96 Resets all subscriber account numbers and CSID in preparation for an initial download.
✻
To Load a Default Set:
97 Enter a number 1-4 corresponding to the selected default table (See the Installation Instructions for the
✻
default tables). Enter 0 if you are not selecting a default table.

To Exit Programming Mode:

98 Exits programming mode and prevents re-entry by: Installer Code + 8+ 0 + 0. If ✻98 is used to exit
✻
programming mode, system must be powered down, then press [✻] and [#] within 50 seconds of power
up to re-enter programming mode.
Exits programming mode and allows re-entry by: Installer Code + 8 + 0 + 0 or: Power-up, then press [✻]
✻99
and [#] within 50 seconds of power up.
Data Field Display
SYSTEM SETUP (✻20– ✻30)
20 20 20 20
INSTALLER INSTALLER INSTALLER CODE INSTALLER CODE CODE CODE
21 21 21 21
QUICK QUICK ARM ARM ENABLE ENABLE
QUICK QUICK ARM ARM ENABLE ENABLE
22 22 22 22
KEYPAD KEYPAD KEYPAD BACKLIGHT KEYPAD BACKLIGHT BACKLIGHT BACKLIGHT
23 23 23 23
FORCED FORCED FORCED FORCED BYPASS BYPASS BYPASS BYPASS
24 24 24 24
RF RF RF RF HOUSE HOUSE ID ID ID ID CODE CODE
HOUSE HOUSE CODE CODE
25 25 25 25
X10 HOUSE X10 HOUSE CODE CODE
X10 X10 HOUSE HOUSE CODE CODE
26 26 26 26
CHIME CHIME CHIME BY BY BY BY ZONE CHIME ZONE ZONE ZONE
27 27 27 27
CLOCK CLOCK CLOCK DISPLAY CLOCK DISPLAY DISPLAY DISPLAY
29 29 29 29
DST MNTH DST MNTH STR/END STR/END
DST DST MNTH MNTH STR/END STR/END

DATA FIELDS

Function& Programming Options
†
Entering a number other than the one specified may give unpredictable results.
Installer Code
[4112]
Enter 4 digits, 0–9
Quick Arm Enable
[1]
†
0 = no; 1 = yes
Keypad Backlight Timeout
[0]
0 = none (backlighting always on); 1 = backlight off after 10secs
Forced Bypass
[0]
†
0 = none; 1 = bypass open zones
RF House ID Code
|
[00]
00 = disable all wireless keypad usage; 01–31 = 5804BD/5804BDV house ID
Powerline Carrier Device (X10) House ID
[0]
0 = A; 1 = B, 2 = C, 3 = D, 4 = E, 5 = F, 6 = G, 7 = H, 8 = I, 9 = J, #10 = K, #11 = L,
#12 = M, #13 = N, #14 = O, #15 = P
Chime By Zone
† [0]
0 = no; 1 = yes (program zones to chime on zone list 3)
Real Time Clock Display
† [1]
0 = no; 1 = yes, display time on keypad
Daylight Saving Time Start/End Month
[3, 11]
Start End
1-9, #+10,#+11,#+12. Enter 0,0 if no daylight savings time used.
[ ] = Programmed Table 1 Default Values
- 3 -
UL installations = 0