Device Programming - Honeywell Lynx Plus Programming Manual

Use this mode to program Powerline Carrier Devices or zone lists for Chime by Zone feature. It is also used to
program the Remote Services Multi-mode (e-mail) event triggers. Press
Note: Entering a number other than the one specified may give unpredictable results.
80 80 80 80
DEVICE PROG DEVICE DEVICE DEVICE PROG PROG PROG MENU MENU MENU MENU
A01 A01
A01 A01
DEVICE DEVICE NUMBER NUMBER
DEVICE DEVICE NUMBER NUMBER
b
DEVICE DEVICE ACTION DEVICE DEVICE ACTION ACTION ACTION
C C C C
START START START EVENT START EVENT EVENT EVENT TYPE TYPE TYPE TYPE
d
START START START START ZONE ZONE ZONE LIST ZONE LIST LIST LIST
E E E E
START ZONE START ZONE TYPE TYPE
START START ZONE ZONE TYPE TYPE
F F F F
STOP ZONE STOP STOP STOP ZONE ZONE ZONE LIST LIST LIST LIST
1A 1A 1A 1A
STOP STOP ZONE STOP STOP ZONE ZONE TYPE ZONE TYPE TYPE TYPE
Powerline Carrier Device Programming
0 = Exit mode, upon which this prompt blinks.
1 = Enter mode
Device Number
Enter the 2-digit device number to be programmed
01-08 = X10 device number
09-16 = Multimode (e-mail) event triggers
[✻] = Continue
00 = Exit Device Programming mode (displays blinking 80; enter ✻ + desired data field or
menu mode number)
Device Action
Enter the 1-digit action, 0-3, for the device being programmed (current action is displayed).
0 = No response
1 = Close for 2 seconds
2 = Close and stay closed
Start Event Type (If applicable)
Enter the 1-digit start event type, 0-3, for the device being programmed.
0 = Not used
1 = Alarm
2 = Fault
Start Zone List (If applicable)
Enter the 1-digit zone list number, 1-3, or 0 if not used, for the device being programmed.
[ ] = Continue
✻
[#] = Return to previous prompt
Start Zone Type (If applicable)
Enter the 2-digit start zone type for the device being programmed (see Powerline Carrier
Device Worksheet for zone type/system operation codes later in this manual).
[ ] = Continue
✻
[#] = Return to previous prompt
Stop Zone List (If applicable)
Enter the 1-digit zone list number, 1-3, or 0 if not used, for the device being programmed.
[ ] = Continue
✻
[#] = Return to previous prompt
Stop Zone Type (If applicable)
Enter the 2-digit stop zone type for the device being programmed (see Powerline Carrier
Device Worksheet for zone type/system operation codes later in this manual).
[ ] = Continue to Device Number prompt (A)
✻
[#] = Return to previous prompt
✻ ✻ ✻ ✻ 80 DEVICE PROGRAMMING
80 while in programming mode.
✻
3 = Pulse on and off
[✻] = Continue
[#] = Return to previous prompt
3 = Trouble
[ ] = Continue
✻
[#] = Return to previous prompt
- 15 -