Table of Contents
Advertisement
Device Programming
This menu is used to program keypads, receivers, and relay modules, etc.
Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression
options, and these settings cannot be changed.
From Data Field Programming mode, press #93 to display "ZONE PROG?" Press [0] repeatedly to display "DEVICE PROG?"
PROMPT
DEVICE PROG?
1=YES 0=NO
0
DEVICE ADDRESS
01-30, 00=QUIT
01
DEVICE TYPE
00
Alpha Keypad
PROMPT
01 CONSOLE PART.
1
01 SOUND OPTION
00
01 KEYPAD GLBL?
0
RF Expander
PROMPT
01 RF EXPANDER
HOUSE ID
00
EXPLANATION
Press [1] to enter Device Programming .
The device address identifies the device to the control. Enter the 2-digit device address number to match
the device's physical address setting (01-30).
Press [✱] to accept entry.
Select the type of addressable device as follows:
00 = device not used
01 = alpha keypad (6160/6160CR-2)
03 = RF receiver (5881ENHC, 5883H)
04 = output relay module (4204)
Press [✱] to accept entry.
EXPLANATION
If you selected device type 01 (alpha keypad), this prompt appears. Enter the addressable device's default
partition number (1 to maximum number of partitions programmed for system in field 2*00). This is the
primary partition for the device. Enter 3 to make this keypad a "Master" keypad for the system.
Press [✱] to accept entry.
If you entered device type 01 (alpha keypad), this prompt appears. Keypads can be individually
programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode beeps. This helps prevent
unwanted sounds from disturbing users in other areas of the premises.
Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:
00 = no suppression
01 = suppress arm/disarm & entry/exit beeps
02 = suppress chime mode beeps only
03 = suppress arm/disarm, entry/exit and chime mode beeps
Press [✱] to accept entry.
If you entered device type 01 (alpha keypad), this prompt appears. Each keypad can give users with access
to multiple partitions the ability to arm and disarm those partitions from it. To enable this keypad for global
arming/disarming, enter 1. To prevent the ability to use this keypad for global arming/disarming, enter 0.
Press [✱] to accept entry.
EXPLANATION
If you selected device type 03 (RF receiver), this prompt appears. Enter the 2-digit House ID (00-31).
Press [✱] to accept entry.
05 = Not used
06 = communicator
09 = Not used
10 = Not used
– 31 –
Hide quick links:
Advertisement
Table of Contents
