Table of Contents
Advertisement
Understanding the printer menus
Use
Bin [x]
Universal Setup menu
Use
Units of Measure
Inches
Millimeters
Portrait Width
3.54–48 inches
89.9–1219 mm
Portrait Height
5.5–48 inches
139.7–1219 mm
Feed Direction
Short Edge
Long Edge
Bin Setup menu
Use
Output Bin
Standard Bin
Bin [x]*
* [x] can be any number from 1 to 4 if the appropriate optional bins are installed. If multiple bins are assigned the same
name, then the name appears only once in the bin list.
To
Specify a custom name for Bin [x].
To
Identify the units of measure.
Notes:
•
Inches is the U.S. factory default setting.
•
Millimeters is the international factory default setting.
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
12 inches is the U.S. factory default setting. You can increase the
width in 0.01‑inch increments.
•
305 mm is the international factory default setting. You can increase
the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
17 inches is the U.S. factory default setting. You can increase the
height in 0.01‑inch increments.
•
432 mm is the international factory default setting. You can increase
the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than the
maximum width supported in the tray.
To
Specify the default bin.
Note: Standard Bin is the factory default setting.
126
Advertisement
Table of Contents
