Advertisement
1.6 Connecting the flue pipe
Lift the upper cast iron top plate off the stove.
Note: the round cast iron cover plate in the top plate must remain mounted if the stove is
being installed with the flue pipe to the rear, but unscrewed from the upper top plate if the
flue pipe is being installed pointing upwards.
Mounting the flue collar pointing upwards
From the factory, the stove is prepared for installation with the included flue collar (1) poin-
ting upwards with included ball stop and screws. The ball stop, which prevents the chimney
sweep from damaging the stove's baffle plates while sweeping, is the 178 mm long rod that
is provided.
Mounting the flue collar to the rear
If the stove is being installed with the flue pipe to the rear, the round plate fixed with two
screws on the back of the stove is dismounted. The iron piece on the inside convection back
panel is knocked out with light, firm taps with a hammer next to the small "bridges" holding
the piece.
The cast iron cover is removed from the back panel by turning it anticlockwise and mounted
on the inside top plate by pressing it down and turning it clockwise. The lid can act as a
cleaning cover, and facilitate access for the annual cleaning of the stove. The flue collar is
centred and screwed onto the back of the stove with the clamps and screws provided. The
ball stop is not used when installing the flue collar to the rear.
The location of the baffles
The baffles (2) and (3), which are made
from vermiculite, are mounted at the fac-
tory.
Make sure that the baffles are correctly
assembled before lighting the stove
(please see the sketch.)
A-A
1
Rev.
Revisions
Title:
Snit til vejledning
2
3
5
Sign.:
Date:
Construction:
RSV
16.11.2010
Released:
Hide quick links:
Advertisement
