Troubleshooting - Yardworks 060-3984-0 Owner's Manual

THE SNOW THROWER DOES NOT START
The Snow Thrower is unplugged.
The lock-out button or trigger switch were
not used properly.
The overload protection switch has popped
out.
THE MOTOR IS ON, BUT THE ROTOR DOES NOT TURN
The belt is damaged.
THE SNOW THROWER LEAVES A THIN LAYER OF SNOW BEHIND
The scraper is worn.
If further assistance is required, contact the Toll-Free Helpline, at 1-866-523-5218.

TROUBLESHOOTING

CAUSE
CAUSE
CAUSE
Verify that the Snow Thrower is plugged into an
electrical outlet.
Press and hold the lock-out button, and then lift
and hold the trigger switch (see the section
entitled Starting the Snow Thrower).
See the section entitled Overload Protection
Switch.
Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
Replace the scraper (see the section entitled
Replacing the Scraper).
17
SOLUTION
SOLUTION
SOLUTION