Yardworks 060-3984-0 Owner's Manual page 15

13
13. Place the pulley back onto
the impellor shaft.
16
16. Replace the pulley
support plate and the 3
retaining screws.
19
spring
19. Place the lower spring into
position and slide the side
cover up using slight pressure
to hold the spring in place.
MAINTENANCE
14
14. Be sure to route the belt
correctly, as shown.
17
impellor shaft
washer and nut
17. Replace and tighten the
impellor shaft washer and nut.
20
20. Replace and tighten the
remaining screws and the nut
and washer.
15
15
15. Replace the 2 spacer
washers on the impellor shaft.
18
spring
18. Place the upper spring
into position and then finger
tighten the cover plate into
place as shown.
21
21. Re-install the impellor
shaft nut and washer on the
right hand side, and tighten.