Troubleshooting - Yardworks SN70112-1 Owner's Manual

Run the snow thrower for a few minutes to melt away any
snow on the snow thrower.
Remove the battery pack from the snow thrower.
Problem
Motor does not start
Poor results
Abnormal vibrations
BATTERY DISPOSAL
Remove the battery pack from the snow thrower. Cover the terminals with heavy duty adhesive tape. Do not attempt to destroy or disassemble battery
pack or remove any components. This product contains lithium-ion batteries which must be recycled or disposed of properly. Local, state or federal
laws may prohibit disposal of these batteries in ordinary trash.
The RBRC seal on the li-ion battery pack indicates that the costs to recycle the battery pack at the end of its useful life has already been
paid by The Great States Corporation American Lawn Mower Company. It is illegal to place spent li-ion batteries in the local municipal
solid waste or in the trash. RBRC in cooperation with The Great States Corporation American Lawn Mower Company has provided an
environmentally friendly and easy way to recycle spent li-ion batteries. Just contact your local recycling center or call 1-800-8BATTERY
for information on where to drop off the spent battery.

TROUBLESHOOTING

Possible causes
Battery not making contact.
Lock off not fully operated.
Battery not installed properly.
Battery not charged.
Drive belt worn or damaged.
Auger worn or damaged.
Discharge blocked.
Drive belt worn or damaged.
Auger worn or damaged.
Scraper blade worn or damaged.
STORAGE
Examine the snow thrower thoroughly for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. To repair or replace parts, contact
customer service help line at 1-800-633-1501.
Store the snow thrower, along with the removed battery
pack, in a clean, dry place out of reach of children. Cover
loosely with a tarp for added protection.
Remedy
Check battery is fully inserted.
Check that lock off button is fully depressed prior to
moving trigger.
Check battery installation.
Check battery charging requirements.
Replace the drive belt.
Replace the auger. Ensure the screws and nuts are
properly tightened.
Switch off the snow thrower, remove the battery
pack, and clean the discharge.
Replace the drive belt.
Replace the auger. Ensure the screws and nuts are
properly tightened.
Replace the scraper blade. Ensure the screws are
properly tightened.
14
Model SN70112-1