Optiset E Local Power Supply - Siemens Optiset E Standard Quick Reference Manual

Optiset E Local Power Supply

The Local Power Supply is required for the Analog Adapter. It
may also be required in other situations, depending on the
Optiset E telephone's configuration, the type of telephone cable
used, the length of the telephone cable from the
communications server, and the type of communications server
used. Only one Optiset E Local Power Supply can be used at a
time on an Optiset E telephone. However, one Local Power
Supply can be used on a primary telephone and a second Local
Power Supply can be used on a secondary telephone attached to
the primary telephone through a Phone Adapter.
Installation of Local Power Supply
To install a local power supply:
1. Disconnect the telephone line from the wall jack and the
telephone. New telephones should have a line cord attached
to the telephone, but may not be plugged into the wall jack.
Plug the line cord (PN 51A4871)
power supply into the jack on the telephone and into the jack
on the power supply labeled
2. Plug one end
the telephone into the jack on the power supply labeled
3. Plug the other end
you could also plug it into an Optiset E Phone Adapter
installed in another properly installed telephone.
4. Plug the power supply
electrical outlet.
Advance Plu
10 Optiset E QRG
of the line cord that you disconnected from
of this line cord into the wall jack. Note,
into a properly grounded 120 Vac
4
Digital
1
that comes with the
.
Digital
2
.
3