Standard Features; Options - AEC AD Series Operation And Installation Manual

1-4

Standard Features

1-5

Options

Page 10
Dual desiccant beds
Electrically-actuated air valve
13X Molecular Sieve
Single regenerative process blower
Drying temperature range of 160ºF to 400ºF.
Mitsubishi programmable relay controller
Display of process temperature set point and actual settings
Process thermocouple to be connected to drying hopper air
inlet.
Nema 12 control enclosure
• NFPA79 machinery electrical standards
• Non-fused electrical disconnect
• Branch fusing
• Mercury process heater contactor
• Regeneration temperature control
• Process high temperature alarm light
• Process/regeneration heater box
• High temperature safety system (Process/Regeneration)
Options can tailor your AEC dehumidifying dryer to meet the
exact requirements of the drying task being performed.
Process temperature up to 400ºF (or below 160ºF), including
aftercooler inside dryer and silicone insulated delivery hose.
Note: For below 160°F, cooler needs to be outside, between dryer and
drying hopper.
If the dryer is a central dry air generator, it will not have a
process heater box.
Plasticizer trap (with cooling coil) in lieu of standard
aftercooler (mounts outside on back of dryer).
Machine mount adapter to accommodate a dryer and
corresponding hopper.
Drawer magnet, stainless steel construction.
Casters, two (2) fixed and two (2) swivel.
AD Series Dehumidifying Dryers