Maintenance; Work Rules; Servicing Process Air Filters - AEC AD Series Operation And Installation Manual

Maintenance

8-1

Work Rules

8-2

Servicing Process Air Filters

Important!
Operating the dryer without the process air filter installed voids
AD Series Dehumidifying Dryers
The installation, operation, and maintenance of this equipment is to
be conducted in accordance with all applicable work and safety
codes for the installation location. This may include, but is not
limited to, OSHA, NEC, CSA, and any other local, national, and
international regulations.
In addition, you must observe the following specific work rules:
Keep these operating instructions on hand and follow them
when installing, operating, or maintaining your dryer.
If the instructions become damaged or unreadable, you can
obtain additional copies from AEC.
Only qualified personnel familiar with this equipment should
work on or with this unit.
Work only with approved tools and devices.
Disconnect power before servicing your dryer. If the
disconnect switch you installed has a lockout, lock it in the
position before you perform any maintenance or service.
OFF
your warranty!
Filter cleaning is an important part of your dryer maintenance
AD dryers have a single cartridge canister-type filter in the process
air loop. The filter protects blowers from plastic fines drawn in
from the drying hopper and prevents the desiccant from being
contaminated. Regular filter cleaning is essential to keep your
dryer operating at peak efficiency.
You can blow or vacuum the dirt out of the filter with compressed
air, but remember, it could become damaged from high-pressure
blowing.
program.
8
Page 53