Powering Off The Et1; Replacing The Battery; Resetting The Et1 - Motorola ET1 Integrator Manual

1 - 4 ET1 Enterprise Tablet Integrator Guide

Powering Off the ET1

Press and hold the Power button until the Device options menu appears. Touch Power off and then OK.

Replacing the Battery

NOTE Do not remove microSD card while in Battery Swap mode.
Ensure that the Battery Swap mode procedures are followed, otherwise the backup battery will deplete
quickly.
To replace the battery:
Press the Power button until the Device options menu displays.
1.
Touch Battery Swap. The Scan LED lights red.
2.
Wait until the Scan LED turns off.
3.
Press thumb against the side of the ET1 and battery. Using the index and middle fingers, move the battery
4.
release latch toward thumb.
Pull the battery out of the battery compartment.
5.
Removing the Battery
Figure 1-2
Align the tracks on the side of the replacement battery with the rails in the battery compartment.
6.
Push the battery in until the battery release latch snaps into place.
7.
Press the Power button to turn on the ET1.
8.

Resetting the ET1

There are four reset functions:
•
Soft Reset
•
Hard Reset
•
Enterprise Reset
Battery Release Latch