Installing The Battery; Charging The Battery; Charging The Main Battery - Motorola ET1 Integrator Manual

1 - 2 ET1 Enterprise Tablet Integrator Guide

Installing the Battery

To install the battery:
Align the tracks on the side of the battery with the rails in the battery compartment.
1.
Push the battery in until the battery release latch snaps into place.
2.
If the battery is charged, press and hold the Power button for two seconds until the splash screen appears.
3.
Inserting the Battery
Figure 1-1

Charging the Battery

CAUTION

Charging the Main Battery

Before using the ET1 for the first time, charge the main battery until the Battery Charge LED turns solid green
(see Table 1-1 on page 1-3
appropriate power supply. For information about the accessories available for the ET1, see
Accessories.
The ET1 is equipped with a memory backup battery that automatically charges from the fully-charged main
battery. When using the ET1 for the first time, the backup battery requires approximately 40 hours to fully
charge. This is also true any time the backup battery is discharged, which occurs when the main battery is
removed for several hours. The backup battery retains RAM data in memory for at least 15 minutes (at room
temperature) when the ET1's main battery is removed, when Battery Swap feature is used. When the ET1
reaches a very low battery state, the combination of main battery and backup battery retains RAM data in
memory for at least 36 hours.
For cable and cradle setup and charging procedures, see
•
USB/Charge Cable
Rails
Ensure that you follow the guidelines for battery safety described in
9-1.
for charge status indications). To charge the ET1, use a cable or a cradle with the
Battery Tracks
Battery Safety Guidelines on page
Chapter 2, Accessories.
Chapter 9,