Lennox icomfort Wi?Fi Thermostat Owner's Manual page 3

Start Up
In event of power failure
—If a power failure occurs,
when the power comes back on, the thermostat will reboot
and when complete, the HOME screen will return.
WHAT THE HOME SCREEN TELLS YOU...
After the thermostat and the
system has been fully connected
and powered on, the icomfort Wi‐Fi
thermostat's Home screen is
displayed. Figure 1 shows a
display and describes what the
thermostat is telling you.
Note that set to heat or cool
communicates that the system
is operating in manual mode;
if it were in program mode,
the heat or cool button would
read summer program is on
(or other named program).
OTHER INFORMATION...
Until and unless the indoor temperature
is at or between the two settings
(70 to 75 degrees in this example), the system
should run until it does measure within that
temperature range.
"Wi-Fi" in the bottom lift corner is the "button" to access
the Wi-Fi settings screen. Wi-Fi with a
a prior connection to the server has been lost. If a connection had
been lost, then re-established, the triangle goes away.
Away Mode sets the thermostat for energy saving while you are gone for an
extended period of time. In this mode, the system will only come on if indoor
temperature falls below 62 degrees (for heating) or if indoor temperature rises
above 85 degrees (for cooling).
heat-to setting cool-to setting
®
indoor
temperature indoor temperature
indoor
humidity
(if feature is
turned on)
indoor humidity is 41%
system
status
Wi-Fi setup
system is cooling
button
Wi-Fi 9:39 am January 23, 2012
time, month, day, year
(press to change)
Figure 1. Home Screen (Typical)
beneath it indicates
WHAT YOU CAN DO FROM THE HOME SCREEN...
(if either feature below
is turned on)
outdoor
system
temperature
mode
outdoor
set temp temperature
80
75
heat
or
cool
cool-to
70
fan is
AUTO
forecast
heat to
Hi 85
Lo 60
use arrows
to change
temperature
fan is
OFF
Zone 1
?
Zoning (if service help screen
installed and alerts are
enabled) present
Adjusting the humidity, even if no physical humidifier or
dehumidifier is present, may also be available, provided the
icomfort Wi‐Fi
Page 3
Typically, what every homeowner wants from an air
conditioning system is to be able to control that
system using a convenient device to
adjust heating, cooling, and the
level of humidity in the home.
Away Mode
From this screen you may:
- adjust temperature
enter
away
settings
Internet
- access menus to change the
weather
forecast
program mode
- change how the
press to go
to Features
fan operates
- access the "Features screen"
(fig. 3) by pressing
fan is set
- access and view active ser­
to AUTO
vice alerts by pressing the
icon
- access help screen by press­
ing the "?" icon.
Adjusting the temperature and changing the
system mode of operation is described fully
beginning on Page 14.
installer has implemented the feature during setup.
See Page 17 for details on humidity control.
®
7-Day Programmable Communicating Thermostat