Lennox icomfort Wi?Fi Thermostat Owner's Manual page 14

Adjusting Room Temperature, Away Mode, Program Change, Clock and Weather
Adjust temperature when programming is OFF—
programming is OFF, the mode button (shown in figure 20, labeled heat or
cool) indicates a manual state (no mention of "program"). In this mode,
change temperature by pressing a set temp button, which produces an up or
down arrow, then use the arrows until the "cool to" (or "heat to") number is at
the desired temperature.
This setting will remain until you decide to change it again. (The inset shows
an alternate configuration of button layout in non-program mode.)
indoor temperature set temp
75
cool-to
70
heat to
indoor humidity is 41%
touch
cool-to
button
system is cooling
Wi-Fi 9:39 am January 23, 2012
Figure 20. Adjusting Temperature with NO Program Running
Away Mode (Vacation)—
screen sets the system for manual operation and allows you to set the ther­
mostat for energy saving while you are gone for an extended period of time.
In this mode, the system will only come on if indoor temperature falls below a
set degree (62 default for heating) or if indoor temperature rises above a set
degree (85 default for cooling). You may adjust those settings as desired
(see figure 21). To exit away mode, press cancel away mode.
507146-01 5/2013
(mode
enter
button)
away
heat
or
cool
set temp
fan is
75
AUTO
fan is fan is
AUTO OFF
cool-to
use arrows
to change
temperature
alternate
cool-only button
layout
? ?
The enter away mode button on the home
When the
9:39 am January 23, 2012 9:39 am January 23, 2012
Wi-Fi
cool
Figure 21. Adjusting Temperature with Program Running
only
fan is Turn Programming ON—
AUTO
pressing the mode button (shown in figure 22, labeled heat or cool). The
manual settings menu includes an option to access programs. Select pro­
grams. The program settings menu takes the place of the manual settings
menu. (Either menu will time out and disappear if you don't make a selection
within a few seconds). Select an option (e.g. spring/fall), The menu disap­
pears and the mode button will display the selected program (e.g.
spring...program is ON).
Turn Programming OFF—
pressing the mode button (e.g. spring...program is ON). The program set­
tings menu includes an option for manual. Select manual. The menu chan­
ges to the manual settings. Select one (e.g. heat only), The menus disap­
pear and mode button will display the selected manual option (e.g. heat
only).
Page 14
system is currently using energy saving AWAY settings
indoor temperature set temp
82
cool-to
60
heat to
use arrows to
change
temperature
(Away Mode)
If the programming is OFF, turn it on by
If the programming is ON, turn it off by
cancel
away
? ?