Lennox icomfort Wi?Fi Thermostat Owner's Manual page 21

ESTABLISHING A WI-FI CONNECTIONS
1. Press NETWORK SETTINGS; this screen shows a graphical view of
buttons representing Wi-Fi options OPEN and SECURE wireless net­
works and a button for adding a network.
WI-FIL SETTINGS
Thermostat is not connected to the Wi-FI network
WI-FI
NETWORK
SETTINGS
enabled
press to change
press to enable /
network settings
disable Wi-FI
Must setup a network connection before registering thermostat
Wi-Fi
Wi-Fi
9:39 am January 23, 2012
!
Figure 39. Enable Wi-FI
S
Open connection which which requires no password.
S
Secure connection which requires Wi-Fi password (security
key).
S
Add a network is required when Wi-Fi identification (SSID) is be­
ing hidden (not broadcasting). You will need to know the Wi-Fi
network name (SSID), security encryption type (if enabled), and
security password (if security encryption is enabled).
X
Zone 1
?
LAWMAC
Open connection (no password required)
DS9
Secure connection (password required)
(lock icon is present)
BSG
Signal strength. For best results, the higher the bar
levels, the more reliable a connection.
Figure 40. Typical Connection Type and Signal Strength
2. When selecting a:
S
unsecured connection a screen will appear with two options,
connect and AP info. Press connect to continue.
S
secured connection a screen will appear requesting the Wi-Fi
network password (security key). There are two options to select
from which are connect and AP info. Using the on-screen key­
board, enter the password (security key) and then press connect
to continue.
NOTE - AP info provides information concerning the home Wi-fi connec­
tion (i.e, RSSI, IP address, MAC address and wait state) all of which may
be helpful in troubleshooting network connection issues).
3. Press connect to complete the connection. Note that "Wi-Fi enable"
button on the Wi-Fi SETTINGS screen changes to "Wi-Fi disable".
icomfort Wi‐Fi
Page 21
®
7-Day Programmable Communicating Thermostat