Switches - CORRECT CRAFT 2011 ski nautique 200og Owner's Manual

Section 4
To lock the system, re-enter any of the three codes and press STOP.
Erasing the User Codes
Make sure the system indicator light is OFF.
Enter the Master Embedded Code, then press and release the 1/2
key and the 7/8 key at the same time to erase the system user codes.
The keyless ignition will now act as if there are no codes in memory.
Pressing the START key will unlock the system and pressing the
STOP key will lock it without entering a code. Follow the steps in
"Programming The Primary User Code" in this section.

Switches

Each electrical circuit on your boat is equipped with a control
switch. The switches have an indicator light for easy ON/OFF
identification. All switches are circuit breaker protected.
Refer to Nautique Dash Pod in this section for additional
information on switch operation.
Underwater Lights
This switch controls the transom underwater lights. DO NOT
operate lights while the boat is out of the water.
Heater Fan (if equipped)
The heater button controls four different heater functions.
Pressing and releasing the "heater" button turns on Low Speed.
Press again for Medium Speed.
Press again for High Speed.
Press again for Off.
The indicator light for this button will illuminate if the heater is
running at any of the three speeds.
4-20