Initial Setup - Air Techniques Accent B5100B Instruction Manual

Note: Turn Control Module off before removing the ACCENT Sensor.
Remove the A C C E N T Sensor by squeezing pulling the sensor cable
plug from the sensor socket of the Control Module.
Make sure that the four NiMH AAA batteries are fully charged prior to use.
Charge batteries in accordance with the NiMH Battery Charger Instruction
Manual, P/N B5087.
Important: Do not run the TWAIN Test program while acquiring images with
another program. Acquiring from two applications causes the
Bluetooth Control Module to lock-up resulting in loss of image data.
If the Bluetooth Control Module locks up, reset by turning the power
OFF and then back ON.

Initial Setup

This procedure teaches Windows about the new Bluetooth device. It
must be performed once on each computer that will use the Accent
Bluetooth Control Module. Perform the procedures as follows:
1. Install the Accent TWAIN Interface and Drivers from the Accent
drivers disk. Insert the Accent Driver disc, the installation pro-
gram automatically runs and opens the A A c c c c e e n n t t D D r r i i v v e e r r s s a a n n d d
M M a a n n u u a a l l s s window shown below.
2. Select I I n n s s t t a a l l l l t t h h e e A A c c c c e e n n t t T T W W A A I I N N I I n n t t e e r r f f a a c c e e a a n n d d D D r r i i v v e e r r s s from the
A A c c c c e e n n t t D D r r i i v v e e r r s s a a n n d d M M a a n n u u a a l l s s window and observe that the A A c c c c e e n n t t
– – I I n n s s t t a a l l l l S S h h i i e e l l d d W W i i z z a a r r d d installer window opens.
Note: A Microsoft® Certification statement may appear.If it does,
click Continue Anyway to proceed with installation.
3. Select N N e e x x t t for all options within the A A c c c c e e n n t t – – I I n n s s t t a a l l l l S S h h i i e e l l d d W W i i z z a a r r d d
installer to load all the software and drivers. Click F F i i n n i i s s h h when done.
I N S T A L L A T I O N
19