System Setup - Air Techniques ScanX Classic Instruction Manual

Classic, Ortho & Intraoral

SYSTEM SETUP

IMPORTANT: ScanX is designed to be installed by your authorized dealer. The user must
provide appropriate and compliant computer hardware. In addition, authorized
Imaging Software purchased from your dealer or other company, must be
installed on the computer in order to operate ScanX.
Site Selection
ScanX may be located almost anywhere in the office . Follow these guidelines for optimum performance:
 Lighting conditions: Set up the scanner in ordinary room light, however, direct sunlight and light fixture(s)
above and near ScanX producing more than 400 lux of light at the PSP inlet must be avoided .
 Provide a stable, flat counter top large enough to hold the scanner, plus provide a working area
for resting and opening cassettes .
 Locate the computer within 6 feet from unit .
 Access to a hospital grade grounded electric Mains AC outlet using the line cord and power supply
adapter provided, must be within line cord length .
Device Driver Installation
Before connecting ScanX to your computer or attempting to use it for the first time, run the Setup program
on the Drivers and Utilities Disk . This CD contains the necessary device drivers to communicate with the
imaging software installed on the user's computer . Normally, this program runs automatically when the
CD is inserted into the drive for the first time . If not, run the Setup program located in the root directory
of the CD (typically D:\Autorun.exe) .
ScanX Connection Procedure
Refer to Figure 2 and perform the following procedure to connect ScanX for operation to a computer
for the first time .
1 . Select a location that meets the Site Selection guidelines .
2 . Make sure that the computer meets all requirements (see page 10) necessary to support ScanX
operation . Set up the computer according to the manufacturer's recommendations .
3 . Verify that an authorized Imaging Software and the supplied USB drivers are installed properly
on the computer .
4 . Connect the high speed USB cable between the USB Type B connector located on ScanX rear
panel and the USB Type A connector located on the computer .
Note: Connect the 24V Power Supply Adapter to ScanX prior to plugging the line
cord into the Mains outlet.
5 . Connect the 24V Power Supply Adapter Output Connection Cable to the Inlet Power Jack located
on ScanX rear panel .
6 . Connect the line cord between the Mains outlet and the 24V Power Supply Adapter . The scanner
is now in the Standby mode .
7 . Switch ScanX from standby to ON by pressing the push button POWER switch ( ) located on
the Control Panel on the front of the scanner . Verify that both the blue LED indicators, for
the READY and ERASER switches, respectively illuminate .
8 . With both ScanX and computer turned on, Windows detects ScanX as a new USB Device and
the Found New Hardware Wizard will appear .
Windows should automatically find the drivers installed from ScanX Drivers and Utilities Disk .
Page 12 Air Techniques, Inc.