Table of Contents
Advertisement
System Properties.
If unsure of the operating system
version installed, check that it
meets the necessary requirements
by checking the S S y y s s t t e e m m P P r r o o p p e e r r t t i i e e s s
window.
This is done simply by right clicking
the M M y y C C o o m m p p u u t t e e r r i i c c o o n n . . Selecting
P P r r o o p p e e r r t t i i e e s s from the menu list displays
the S S y y s s t t e e m m P P r r o o p p e e r r t t i i e e s s window as
shown. The installed operating
system version is listed under the
G G e e n n e e r r a a l l T T a a b b . .
The S S y y s s t t e e m m P P r r o o p p e e r r t t i i e e s s window can
also be displayed from the Desktop
S S t t a a r r t t button. Just press the S S t t a a r r t t but-
ton and select S S e e t t t t i i n n g g s s C C o o n n t t r r o o l l
P P a a n n e e l l and then S S y y s s t t e e m m . .
The Bluetooth AC C E N T system is comprised of a AC C E N T Sensor
(size 1 or size 2) with attached connection cable and a Bluetooth Control
Module allowing wireless connection. The ACCENT Sensor is connected to
the Control Module via a 4-foot (1.25 meter) cable. The Control Module
connects to the user-supplied computer system using the Bluetooth wire-
less connection protocol.
During operation of the ACCENT system, the X-ray beam is converted
into an electronic signal by the ACCENT Sensor. The resulting image
information is digitized using a 12-bit A/D converter and then stored in
the Control Module.
The image memory of the Control Module reduces the possibility of
image loss caused by interference or misuse. The image is transferred
block by block to the user-supplied computer system and processed by
the image software.
Only one image can be processed during a data transmission cycle,
which is indicated by an illuminated front-panel blue LED indicator. New
images can be created when the front-panel yellow LED indicator starts
blinking.
The A C C E N T can only be used when connected via the wireless
Bluetooth protocol to a user-supplied computer system loaded with an
Image Management Software authorized by Air Techniques.
Each time the A C C E N T Sensor is used it must be covered with an
appropriate disposable infection control sheath (PN B5125 or B5225).
COMPUTER REQUIREMENTS
F U N C T I O N A L D E S C R I P T I O N
13
Advertisement
Table of Contents
