Table of Contents
Advertisement
Sensor Care
To prevent damage to the A C C E N T sensors, please read and act on
the following suggestions
DO
wipe down the sensor with a sterile solution
DO
store the sensor in the Sensor Storage Hanger or its hard
shell shipping case when it is not in use.
DO
keep the sensor and the remote off of the floor at all times
DO
use proper bite holders, tabs and sterile sheaths every time
the sensor is used.
DON'T
a a u u t t o o c c l l a a v v e e the sensor
DON'T
s s o o a a k k the sensor or its connector in disinfecting solution
c c l l a a m m p p the sensor or its cable with a hemostat or equivalent
DON'T
DON'T
p p u u l l l l the sensor by its cable during sheath removal
h h a a n n g g the sensor by its cable
DON'T
DON'T
allow anyone to b b i i t t e e on the sensor
Cable Care
Improper storage, handling or uncoiling of a sensor cable is the most
common cause of sensor failure. It is important that the following
instructions are read and acted on to prevent cable damage.
DO
uncoil sensor gently by letting the connector hang down
while holding sensor
DO
carefully remove all tangles and sharp bends while
uncoiling cable
DO
ensure cable is completely uncoiled and has no kinks or
sharp bends in it before each use
DO
grasp the connector, not the cable, when disconnecting the
sensor from the remote, and pull gently
DO
hold onto the sensor body while removing any tabs,
holders, or sheaths. Be as gentle as possible
let the cable hang on or n n e e a a r r t t h h e e f f l l o o o o r r where it can
DON'T
become tangled
DON'T
let the cable hang n n e e a a r r a a d d r r a a w w e e r r where it can be kinked
p p u u l l l l o o n n t t h h e e c c a a b b l l e e to remove from tab, holder or sheath
DON'T
DON'T
t t a a n n g g l l e e c c a a b b l l e e during use
c c r r e e a a t t e e s s h h a a r r p p b b e e n n d d s s or knots when untangling
DON'T
C A R E A N D M A I N T E N A N C E
27
Advertisement
Table of Contents
