Connecting Power - JVC KY-F70B Instructions Manual

2. Before recording (continued)

Connecting power

Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA
terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided.
AC
White marking
Connect the end with the
white marking to the AC
adapter.
CAUTION
• Be sure to use the AA-P700 power supply.
• Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF.
Connecting with the power switch on may result in camera malfunction.
MEMO
• Wait at least 10 seconds before turning the power switch back on, when it has just been turned off.
• Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc.
Figure 1
Plug
Figure 2
Figure 3
E18
AA-P700
DC 12V=OUTPUT
S(Y/C) OUTPUT
EITHER
OUTPUT
MAX 1.25A
AC adapter
Ring
VIDEO OUTPUT
TO CAMERA
SEE INST-
RUCTION
MANUAL
Provided power cable
After inserting the plug completely, tighten the secur-
ing ring. (Figure 1)
Make sure white indication of power cable comes to
AA-P700 side.
To minimise emission of unwanted electrical waves,
mount certainly the provided clamp filter as shown in
Figure 2 and 3 on the left.
Wind the power cable once around the clamp filter.
Ensure that the clamp filter is mounted as close to
the camera as possible as shown in the diagram.
SCSI
REC
MODE
SEND AW/SEL
MENU UP DOWN SET
PLAY
FREEZE
LENS
MONITOR
REMOTE
DC IN
POWER
ON 1 2 3 4
SEE INSTRUCTION MANUAL
Provided
Clamp filter