Print Language; Print Character Table; Active Print Language; Pa1 - IBM 6500 User Manual

Print Language

PRINT LANGUAGE specifies the set of print languages used by the printer. Refer
to the previous page for print language menus.
v Standard Print Language (the default)
v Alternate Print Language. Provides code pages compatible with 6408/6412
Model CT0 printers. Use this option with the 3287 printer emulation.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and OCR
B are the only available values for this parameter. If a different print quality value
is desired, the print language must be changed first.

Print Character Table

PRINT CHARACTER TABLE prints out a table of the coax interface current
character set.
All coax character sets are shown in the 6500 Coax/Twinax Programmer's Reference
Manual.

Active Print Language

ACTIVE PRINT LANGUAGE specifies which print language set will be the active
set.
v Standard Print Language (the default)
v Alternate Print Language

PA1

PA1 is only valid when the printer is in the NOT READY state and the coax
System Network Architecture Character Set (SCS) data stream is active. This
function displays the "PA1 ENABLED" message when the Enter key is pressed
and sends a special operator request to the host when the printer is made READY.
v Disable (the default)
v Enable
Refer to the 6500 Coax/Twinax Programmer's Reference Manual for more information
about SCS.
Note: Selecting the PA1 menu item again ("PA1 DISABLED" appears on the
operator panel) or selecting the PA2 menu item will reset the pending PA1
function.
Chapter 4. The Configuration Menus
79