Bezel Blank - Compaq Deskpro 4000N Maintenance & Service Manual

5.16.3 Bezel Blank

This operation applies to the Deskpro 4000S only.
To remove the bezel blank, complete the following steps:
1. Prepare the computer for disassembly (Section 5.4).
2. Remove the system unit cover (Section 5.7).
3. Set the system unit cover with the top down on a protected work surface. Squeeze together the
sides of the right end of the bezel blank to release the catches.
4. Remove the bezel blank from the front bezel.
Figure 5-21. Removing the Bezel Blank (Deskpro 4000S Shown)
To reinstall the bezel blank, reverse the above procedure.
5-30 Removal and Replacement Procedures