Compaq Deskpro 4000N Maintenance & Service Manual page 77

Figure 5-2. Chassis Mounting Screw Holes
10. Position the computer in the desired area and mark through the mounting holes to accurately
locate where the fasteners will be installed.
11. Move the computer; then drill pilot holes in the mounting surface if required to accept the
fasteners.
CAUTION: Do not drill any holes through the computer chassis. Use the existing holes in the chassis to
layout the location of the desired holes.
12. Reposition the computer and install the fasteners through the computer chassis.
CAUTION: Use only #6 FH screws to mount the computer. A larger screw may damage or interfere with
the system board tray.
CAUTION: Carefully clean the cavity of the chassis to remove any foreign particles before reinstalling the
computer components.
13. Reinstall the balance of the computer components and the system unit cover.
Compaq Deskpro 4000S and 4000N Personal Computers 5-3