Preparing For Drive Installation; Removing The Bezel Blank - Compaq Evo W8000 Hardware Reference Manual

Preparing for Drive Installation

Removing the Bezel Blank

Compaq Evo Workstation W8000 Hardware Reference Guide
Remove the drive bezel blank before installing any removable media
storage device, such as a tape drive, CD-ROM or DVD-ROM drive,
or diskette drive, into an empty bay location.
To remove the bezel blank:
1. Shut down the operating system properly, then turn off the
workstation and any external devices. Disconnect the power
cord from the grounded AC outlet.
2. Remove the workstation access panel. See "Removing the
Workstation Access Panel" in this chapter.
3. Remove the front bezel. See "Removing the Front Bezel" in this
chapter.
4. Remove the bezel blank:
a. Pinch together the retainer snaps on the back of the front
1
bezel . This allows the bezel blank to move past the
retainer snaps.
b. Rotate the bezel blank outward
front bezel.
Removing the bezel blank from the front bezel
Hardware Upgrades
2
, detaching it from the
2-21