Monitoring The Transmissio Frequency; Setting The Channel Number With Keypad - JRC JSS-296 Instruction Manual

3.4.2.2 Monitoring the transmission frequency
In semi-duplex mode the TX/RX frequency are set differently , though only one way transmission or
reception is possible at the same time. The transmission frequency signal can be checked for
interference.
LISN/
1. Press
TX
JSB-196 starts to receive TX frequency. After the check, press
return to the initial state.
3.4.2.3

Setting the channel number with keypad

User channel number can be set with keypad as follows.
Procedure
Example of user channel number 101 (RX
frequency 26145.0 kHz / TX frequency
25070.0 kHz).
CH
1. Press
"GROUP 1 TEL" appears in the channel
field of the LCD.
1
2. Press ,
The channel number is displayed in the
channel field of the LCD.
User channel number: 1 to 200
Note
ITU channel number:
TEL: 401 to 2517 CW : 401 to 2524
TLX: 401 to 2571 DSC: 401 to 2503
3. Press
ENT
The input channel number is fixed.
4. Input the RX/TX frequency.
See the 4.3.3.6 Registering the user channel
step 4 7 .
5. If TUNE is blinking, press
TUNE
lights steadily during tuning, and
disappear when tuning is completed.
6. With these steps, the JSB-196GM is ready
to communicate. Start communication by
pressing PTT on the Hand set.
Note
At channel setting, current mode must not be DSC mode.
.
.
0 1
and .
.
ANT
.
TUNE
Procedure
Examples of display on the LCD
RX FREQ
RDY
RDY
TX FREQ
RX FREQ
RDY
TX FREQ
LISN/
again or transmit to
TX
(in the TEL mode)
, , , , . . . .
, , , , . . . .
, , , , . . . .
, , , , . . . .
NB
KHz
AGC
TUNE
KHz
NR
KHz
AGC
TUNE
KHz
3-9