Table of Contents
Advertisement
User's Manual
Scan: Click to find and list up devices connected to a network. (Network cameras, network video transmitters,
network video receivers and MMXs only)
Add: Select the device in the device list and click the button to register the device on the network keyboard.
A setup screen appears allowing you to enter the information for connection to the device.
PTZ Camera
– ID: The network keyboard assigns the ID automatically when the device is registered, and you can
change the ID. The ID will be used to distinguish the device from other devices when controlling it
by using the network keyboard, so each device should have its own unique ID.
– Name: Set up the device's camera name for your reference.
– Camera Channels: Select the number of camera channels supported in the device.
38
– Auto Scan: Click to reload the list of the device networked
via LAN.
– Manual Scan: Click the button and enter the IP address of
the device to find out when the device is networked via WAN
or temporarily disconnected from the network.
– Add: You can register the listed device on the network
keyboard. Check the devices in the list and click the button,
and a setup screen appears. Enter the user ID and password
for the connection to the selected devices and click the OK
button. Do not check the Apply to all box if the user ID and
password of selected devices are different from each other, and
the OK button changes to Next. Click the Next button and
enter the information for connection to each device. Refer to
the following section for details of the information setup.
Network Camera,
Network Video Transmitter,
Network Video Receiver
Scan, Add, Edit: See below.
Remove, Remove All: Select a device in the list and
click the Remove button to delete it. Clicking the
Remove All button deletes all devices from the list.
DVR
MMX
Advertisement
Table of Contents
