Mmx System Registration - CCTV Intelligent Network Keyboard User Manaul

User's Manual

2.4 MMX System Registration

You can register MMXs to control via network connection. The MMX can be controlled only in the Advanced
mode by using the INIT program and not in the Basic mode.
1. Connect a MMX to a network referring to the MMX's User's Manual.
2. Run the INIT program and connect to the network keyboard to register the MMX. Refer to the INIT
User's Manual for details on the INIT program.
3. Go to the following menus: Setup → Remote Setup → Network
→ IP Address
Set up the network keyboard's network connection information.
4. Go to the following menus: Setup → Remote Setup → Device
→ General
Select Advanced from the Setup Type drop-down list.
5. Go to the following menus: Setup → Remote Setup → Device
→ Setup
5.1. Click Digital Video Recorder in the device list, and then
the Add button to register a DVR connected to the MMX.
You can control the DVRs by using a network keyboard.
5.2. Set up the registration information and click the OK button.
ID: The network keyboard assigns the ID automatically when the DVR
is registered, and you can change the ID. The ID will be used to
distinguish the DVR from other devices when controlling the DVR by
using a network keyboard, so each device should have its own unique ID.
Connection: Select Ethernet and enter the IP address, port numbers
(Control Port: Watch port), user ID and password for the connection
to the DVR.
14