CCTV Intelligent Network Keyboard User Manaul page 19

4. Go to the following menus: Setup → Remote Setup → Device
→ General
Select Advanced from the Setup Type drop-down list.
5. Go to the following menus: Setup → Remote Setup → Device
→ Setup
5.1. Click Network Camera, Network Video Transmitter or
Network Video Receiver in the device list, and then the
Scan or Add button to register the device.
5.2. Set up the registration information and lick the OK button.
ID: The network keyboard assigns the ID automatically when the device
is registered, and you can change the ID. The ID will be used to
distinguish the device from other devices when controlling it by using
a network keyboard, so each device should have its own unique ID.
Connection: Select Ethernet and enter the IP address, port numbers
(transmitter: Watch port, receiver: Control port), user ID and password
for the connection to the network device.
5.3. Click the Network Camera, Network Video Transmitter
or Network Video Receiver pull-down menu in the device
list, and then the registered device's pull-down menu. A list
of monitors or cameras supported in the device is displayed.
[ID] Main Monitor: Displays the monitor ID and type.
[ID] 'Camera Name': Displays the ID and name of the
camera.
5.4. Click a monitor or a camera in the list, and then the Edit button. Set up
the monitor or camera information.
ID: The network keyboard assigns the ID automatically when the device
is registered, and you can change the ID. The ID will be used to
distinguish the monitor or camera from other monitors or cameras when
controlling it by using a network keyboard, so each monitor or camera
should have its own unique ID.
Type: Set up the camera type.
Fixed: Select if the camera is not a PTZ camera.
−
PTZ Camera: Select if the camera is a PTZ camera, and then select
−
the device that controls the PTZ camera.
Network Keyboard
13