Factory Reset; Top Panel - CCTV Intelligent Network Keyboard User Manaul

CAUTION: Do NOT connect or disconnect the joystick cable while the network keyboard is
powered up. The network keyboard must be powered down to connect or disconnect the
joystick cable; otherwise, it might cause damage or malfunction on the network keyboard.

Factory Reset

CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
You can perform a factory reset while the network keyboard is turned on. Poke a straightened paperclip
into the factory reset switch hole and hold the switch for about three seconds. Releasing the reset switch
performs factory reset. A factory reset also can be performed remotely by running the INIT program. The
network keyboard restarts after completing the factory reset. Refer to INIT User's Manual for details on
remote factory resetting.

1.7 Top Panel

No. Designation
Joystick
1
PTZ Camera
2
Control Buttons
LCD Screen
3
Device Control
4
Buttons
Arrow Buttons
5
Controls pan and tilt of a PTZ camera by using the stick or zoom of a PTZ
camera by using the shuttle ring.
Controls the PTZ camera by setting up presets or expanded PTZ features.
Refer to Appendix – Buttons, PTZ Camera Control (p. 45) for details.
Displays operation commands or LCD menus. Refer to Chapter 3 —
Operation (p. 17) and Chapter 4 — LCD Menu Configuration (p. 29) for
details.
Controls remote devices including DVRs. Refer to Appendix – Buttons,
Device Control (p. 45) for details.
Allows you to navigate through setup menus or adjust number's value during
the configuration.
Details
Network Keyboard
7