Table of Contents
Advertisement
User's Manual
4.3 Setup Menu
System
General
Version
Password
Default Settings
MAC Address
Button
Beep
Lock
LCD
Contrast
Backlight Off
Audio
Volume
Upgrade
Device
General
Setup Type
Port
30
Displays the software version.
Sets up the Admin password or User password (max. four digit numbers).
Entering the current password allows you to enter a new password,
and there is no default password. The Admin password is required to
connect to the network keyboard and set up the LCD menu, and the
User password is required to control the network keyboard.
This setting will only be used on the rare occasions that you want to
return all the settings to the original factory settings. Refer to Chapter 1
— Introduction, Factory Reset (p. 7) for details.
Displays the MAC address.
Setting the value to ON makes the network keyboard beep when pressing
buttons.
Locks the buttons. The buttons will be locked when there is no action
on the network keyboard during the preset time after the last action.
Unlocking the buttons requires entering the User password. This function
does not work if the User password is not set up or the time is set to "0."
Adjusts the contrast of the LCD screen. (1: Low, 2: Medium, 3: High)
Adjusts the backlight time (min.) of the LCD screen. The backlight
will be turned off when there is no action during the preset time after
the last action. This function does not work if the time is set to "0."
Adjusts the volume of audio input and output.
Setting the value to Yes upgrades the software. Refer to Chapter 1 —
Introduction, Software Upgrade (p. 6) for details.
Selects the setup mode. Select Basic or Advanced when controlling
devices via RS485 connection only, or select Advanced when
controlling devices via network and RS485 connections. When in
the Advanced mode, you can register devices only by using the INIT
program.
Selects the device to control via RS485 connection and sets up the
RS485 port information for RS485 communication. The port information
is set up separately for PTZ cameras and DVRs. When in the Advanced
mode, you can set up the port information of DVRs only. If you want
to set up the port information of PTZ cameras in the Advanced mode,
you have to run the INIT program. If the port information of PTZ
cameras is different from each other, the cameras can be controlled in
the Advanced mode only and not in the Basic mode.
Advertisement
Table of Contents
