Table of Contents
Advertisement
User's Manual
5.3. Click the Digital Video Recorder pull-down menu in the
device list, and then the registered DVR's pull-down menu.
A list of monitors and cameras supported in the DVR is
displayed.
[ID] Main Monitor: Displays the monitor ID and type.
[ID] Spot Monitor No.: Displays the monitor ID,
monitor type and the Spot Out number of the DVR.
[ID] 'Camera Name': Displays the ID and name of
the camera.
5.4. Click a monitor or a camera in the list, and then the Edit button. Set up
the monitor or camera information.
ID: The network keyboard assigns the ID automatically when the DVR
is registered, and you can change the ID. The ID will be used to
distinguish the monitor or camera from other monitors or cameras when
controlling it by using a network keyboard, so each monitor or camera
should have its own unique ID.
Type: Set up the camera type.
Fixed: Select if the camera is not a PTZ camera.
−
PTZ Camera: Select if the camera is a PTZ camera, and then select
−
the device that controls the PTZ camera.
2.3 Network Matrix System Registration
You can register the network video transmitters, network cameras and network video receivers to control
via network connection. The devices can be controlled only in the Advanced mode by using the INIT program
and not in the Basic mode.
1. Connect a network device to a network referring to each device's User's Manual.
2. Run the INIT program and connect to the network keyboard to register the device. Refer to the INIT
User's Manual for details on the INIT program.
3. Go to the following menus: Setup → Remote Setup → Network
→ IP Address
Set up the network keyboard's network connection information.
12
Advertisement
Table of Contents
