CCTV Intelligent Network Keyboard User Manaul page 17

3. Go to the following menus: Setup → Remote Setup → Network
→ IP Address
Set up the network keyboard's network connection information.
4. Go to the following menus: Setup → Remote Setup → Device
→ General
Select Advanced from the Setup Type drop-down list. If
the DVR is connected to the network keyboard via RS485
connection, set up the port information for RS485 communication.
5. Go to the following menus: Setup → Remote Setup → Device
→ Setup
5.1. Click Digital Video Recorder in the device list, and then
the Add button to register the DVR.
5.2. Set up the registration information and click the OK button.
ID: The network keyboard assigns the ID automatically when the DVR
is registered, and you can change the ID. The ID will be used to
distinguish the DVR from other devices when controlling the DVR by
using a network keyboard, so each device should have its own unique ID.
Connection: Select RS485 or Ethernet depending on the connection
type.
RS485: Enter the DVR's system ID set in the DVR if the DVR is
−
connected to the network keyboard via RS485 connection. You have
to change the DVR's system ID in the DVR if the system ID is in use
in more than one DVR or set to "0." The system ID will be used to
distinguish the DVR from other DVRs when controlling it by using a
network keyboard, so each DVR should have its own unique system ID.
Ethernet: Enter the IP address, port numbers (Control Port: Watch
−
port), user ID and password for the connection to the DVR if the DVR
is connected to a network.
Network Keyboard
11