Jumpers And Connectors; Setting Jumpers - Advantech PPC-150 Series User Manual

5.1 Jumpers and Connectors

5.1.1 Setting jumpers

You can configure your panel PC to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electrical switch. It consists
of two metal pins and a small metal clip (often protected by a plastic cover)
that slides over the pins to connect them. To "close" a jumper, you connect
the pins with the clip. To "open" a jumper you remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2, and 3. In this case, you would
connect either pins 1 and 2 or pins 2 and 3.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before you
make any changes.
48 PPC-150
Open Open
Open Open Open
Open Open Open Closed Closed Closed
Open Open Closed Closed
User's Manual
Closed Closed
Closed Closed Closed
3
2
1
Closed 2 - 3 Closed 2 - 3
Closed 2 - 3 Closed 2 - 3 Closed 2 - 3
1
Closed 2 - 3 Closed 2 - 3 Closed 2 - 3
Closed 2 - 3 Closed 2 - 3