Installing The Drivers - Advantech PPC-150 Series User Manual

Power on your panel PC or reset the system by pressing the
"Ctrl"+"Alt"+"Del" keys simultaneously. The panel PC will automatically
load the operating system from the diskette or CD-ROM.
If you are presented with the opening screen of a setup or installation
program, follow the instructions on screen. The setup program will guide you
through preparation of your hard drive, and installation of the operating
system.
If you are presented with an operating system command prompt, such as
A:\>, then you must partition and format your hard drive, and manually copy
the operating system files to it. Refer to your operating system user's manual
for instructions on partitioning and formatting a hard drive.

2.6 Installing the Drivers

After installing your system software, you will be able to set up the Ethernet,
SVGA, audio, and touchscreen functions. All the drivers except the CD-
ROM drive driver are stored in a CD-ROM disc entitled "Drivers and
Utilities". The CD-ROM drive driver is stored in a floppy disk. Both the CD-
ROM and the floppy disk can be found in your accessory box.
To set up the CD-ROM function, insert the floppy disk with the CD-ROM
drive driver into the floppy disk drive and type "install" after the following
prompt is displayed on screen:
A: > INSTALL
Press "Enter", and the installation process will be completed in a few
seconds.
The standard procedures for installing the Ethernet, SVGA, audio, and
touchscreen drivers are described in Chapters 6, 7, 8 and 10 respectively.
For your reference, the directory of drivers on the "Drivers and Utilities" CD-
ROM is:
Chapter 2 System Setup 23