Calibration Screen - Motorola MC3000 User Manual

1 - 10 MC3000 User Guide
On Windows CE 5.0 configurations, after the calibration procedure is performed the factory settings launch the
Demo window. Application specific shells may provide application specific windows instead of the Demo window.
These screens also appear when a cold boot is performed.
If the mobile computer does not power on, see

Calibration Screen

Use the
Calibration
Remove the stylus from the stylus holder.
1.
Carefully press and briefly hold the stylus tip on the center of the
2.
procedure as the target moves and stops at different locations on the screen. This enters the new calibration
settings.
Calibration Screen
Calibration Screen
Figure 1-8
Once all of the new calibration settings are input, tap the screen or press the
3.
calibration settings. Press
Demo Window (Windows CE Only)
The
Demo window
appears. These sample/demo applications are intended to be used by application developers as application
development examples. These applications were not developed to support end users. Refer to the Application
Guide for Motorola Enterprise Mobility Devices for information about the
Demo Window
Figure 1-9
screen to align the touch screen:
Confirm Calibration
Resave Screen
to discard the new calibration settings.
ESC
is the factory default menu. On initial power up (or on a warm or cold boot) the
Resetting the Mobile Computer on page
Calibration
Demo window
2-34.
screen target. Repeat the
button to save the new
ENTER
Demo window
applications.