Spare Battery Charging; Starting The Mc21Xx; Calibration Screen - Motorola MC21XX SERIES Integrator Manual

Spare Battery Charging

To charge a spare battery:
Connect the Four-slot Battery Charger to the appropriate power source. See
1.
setup instructions.
Insert the spare battery into the spare battery charging slot and gently press down on the battery to ensure
2.
proper contact.
The battery starts to charge automatically. The LED Indicator blinks amber to indicate the battery is charging.
See Chapter 2, Accessories

Starting the MC21XX

Press the Power button to turn on the MC21XX. If the MC21XX does not power on, perform a cold boot. See
Resetting the MC21XX on page 2-12.
When the MC21XX is powered on for the first time, it initializes. The Splash screen appears for a short period
of time. On the MC2180 the Calibration screen appears.
If the MC21XX does not power on, see Resetting the MC21XX on page 2-12.

Calibration Screen

NOTE MC2180 only.
Use the
Calibration
Remove the mini stylus from the back of the MC2180.
1.
Carefully press and briefly hold the stylus tip on the center of the
2.
procedure as the target moves and stops at different locations on the screen. This enters the new
calibration settings.
Calibration Screen
Figure 1-5
Once all of the new calibration settings are input, tap the screen or press the
3.
new calibration settings. Press
for charging indications. The battery usually fully charges in less than four hours.
screen to align the touch screen:
to discard the new calibration settings.
ESC
Getting Started
Chapter 6, Accessories
screen target. Repeat the
Calibration
button to save the
ENTER
1 - 5
for