Operating The Cleaner; Installing The Vacuum Cleaning Robot; Installation Order; Turning The Power Switch On Or Off - Samsung SR10F71U series User Manual

operating the cleaner

INSTALLING THE VACUUM CLEANING ROBOT

Installation order

1. Turning the Power Switch on or off

To use the vacuum cleaning robot, you must turn on the Power Switch
at the bottom of the main unit.

2. Installing the Charger

To charge the vacuum cleaning robot, you must first install the charger.
Since the battery is discharged when the product is purchased, you
must fully charge the battery before use.
3. Charging the Battery
You should charge the battery completely before using the vacuum
cleaning robot.
4. Setting the Time
You should set the time to use the scheduled and daily cleaning options.
5. Installing the VIRTUAL GUARD
You can confine the vacuum cleaning robot to a particular section by using Fence (virtual wall)
mode.
Turning the Power Switch on or off
To use the vacuum cleaning robot, you must turn the Power Switch
on.
If you turn off the Power switch, all settings except for the current
time and the Weekly reservations are reset.
❈ If no key is pressed for approximately 1 minute after turning the
power on, the power is automatically cut to prevent the battery
discharging.
To turn the power on again, press and hold the power (
button on the main body.
1. Lift the body and turn on the power switch while making
sure not to press any other button.
- If the icons are not turned on, it indicates that the battery charge
is depleted. In this case, dock the vacuum cleaning robot to the
charger station after turning the Power Switch on.
- The configured time may be different from the current time. If the
configure time is incorrect, set the time to the current time.
If the Power Switch is turned off, the vacuum cleaning robot will
CAUTION
not be charged even if it is docked with the charger station.
20_ operating
)