Cleaning And Maintenance - Samsung SR10F71U series User Manual

Do not move the robotic vacuum cleaner holding the dustbin
part.
CAUTION
- This may cause the dustbin to separate, resulting in injury or
serious damage to the product.
Vacuum cleaning robot may not be able to continue its
operation if it is stuck at the entrance or veranda doorsill.
NOTE
- To resume operating, turn the Power Switch off and then on again
after moving it to a location where it can continue cleaning.
Vacuum cleaning robot cannot completely clean locations that
it cannot reach, such as corners, and spaces between sofas
NOTE
and walls.
- Please clean these locations occasionally.
Dust clusters may remain after cleaning, when the vacuum cleaning robot fails to
pick up dust clusters that were formed while cleaning.
NOTE
- In this case, sweep up the dust with another cleaning tool.

CLEANING AND MAINTENANCE

When cleaning the product, do not spray water directly onto
the exterior or wipe it with a volatile material such as benzene,
CAUTION
thinner or alcohol.
- This may result in critical damage to the product.
The unit must not be disassembled or reconstructed by anyone
other than a qualified service engineer.
CAUTION
- This may result in damage to the product.
Remove any foreign substances accumulated on the Obstacle
and Cliff sensors on a regular basis.
WARNING
- Dirt accumulated on the sensors will result in inaccurate
functioning of the sensors.
Cliff sensor
Obstacle sensor
safety information _11