Push-Pull Cable Adjustment - Gizmow Formula Operator's Manual

Maintenance & Adjustment
c. To adjust the switches you can deform the mount to align with the appropriate
pump arm. Loosen the two screws holding each switch (or the magnet located
on the pump arm) to align the magnet to the sensor. These should be aligned
so that there is no more than 1/8" gap max. between the two when the
machine is in neutral.

5.2.11 Push-pull cable adjustment

a. Set the push-pull cables in the rear of the machine so that three full threads
protrude through the holder as shown.
b. Remove the front nose cover, side covers and access panel.
c. Set the steering so the wheels are pointed straight.
d. Depress the Forward pedal and
engage the cruise control so it
is held in the full forward
position.
e. Adjust the push-pull cables so
that the bearings are close to
but not touching the cams for
Top and Bottom. There should
be 2 mm of clearance between
the cam and roller. Top cam
adjustment is shown below.
The adjustment for the Bottom
cam is the same as the top.
f. Release the cruise control.
g. Turn the wheel all the way to
the right until it hits the wheel stop.
h. Prop the seat up.
40
Formula - 20071