Adjustments; Wheel Hub - Slotted Nut Torque Specification; Cutting Height Indicator Adjustment; Anti-Scalp Wheel Adjustment - Gizmow Formula Operator's Manual

5.1.25 Wheel hub
specification
When tightening the slotted nut on the wheel
motor tapered shaft:
a. Torque the slotted nut to 175 ft. lbs.
b. Further tighten the nut until the next
set of slots line up with the cross hole
in the shaft.
c. Replace cotter pin.
IMPORTANT: Both the wheel hub and the
tapered shaft must be clean and dry before
assembly.
5.2

ADJUSTMENTS

IMPORTANT: Disengage PTO, shut off engine, wait for all moving parts to stop, and
remove key before servicing, cleaning or making any adjustments to the unit.
5.2.1

Cutting Height Indicator Adjustment.

a. Stop machine and set parking brake.
Shut off engine and remove the key.
b. Move the toggle switch up to raise
the deck to the full height of 5".
c. Check the height shown on the
indictor on the right side of the
machine. If it is not at 5" loosen the
two 5/16" bolts/nuts to adjust. Re
tighten the bolts after adjustment.
5.2.2

Anti-scalp wheel adjustment

a. Stop machine and set parking brake.
Shut off engine and remove the key.
b. Position the anti scalp wheels as shown for the height of cut to be used.
Formula - 20071
Maintenance & Adjustment
- slotted nut torque
1 to 2 1/4
2 1/4 to 5
35