Check Hydraulic Oil Level; Check Tyre Pressures; Check Condition Of Belts; Lubricate Grease Fittings - Gizmow Formula Operator's Manual

c. Clean around oil fill cap and remove cap. Fill to specified capacity and replace
cap. Use oil recommended in engine owner's manual. DO NOT overfill.
d. Start the engine and check for leaks. Stop engine and re check oil level.

5.1.10 Check hydraulic oil level

Service Interval: 40 hr.
a. Stop engine and wait for all moving parts to stop.
b. Clean area around hydraulic reservoir cap and remove cap.
c. Oil level should be to the first line on the dipstick when cold (check with
dipstick screwed onto the tank and remove to check). If not add oil. Use only
Mobil 1 15W-50 synthetic motor oil. Replace hydraulic reservoir cap and
tighten until snug. Do not over tighten.
NOTE: There are two lines on the dipstick. The oil level varies with the temperature of the
oil. The top line on the dipstick level shows the level of oil when it is at 225F (107C) - HOT.
The bottom line on the dipstick shows the level of the oil when it is at 75F (24C) - COLD.
Fill to the appropriate level depending upon the temperature of the oil in the machine. If
the oil is at room temperature (about 75 F (24C)), fill only to the COLD level.

5.1.11 Check tyre pressures

Service Interval: 40 hrs.
a. Stop engine, wait for all moving parts to stop, and remove key.
b. Check tyre pressure in all four tyres.
c. Inflate front tyres to 16 psi (1100 kPa).
d. Inflate drive tyres to 16 psi (1100 kPa).

5.1.12 Check condition of belts

Service Interval: Initially at 4 hours – thereafter every 40 hrs.
a. Stop engine, wait for all moving parts to stop, and remove key.
b. Check behind engine to check gearbox drive belt. Check in front of engine to
check hydro drive belt.
c. Remove left and right belt shields on deck and lift up floor pans to inspect the
deck drive belts.
d. See Sections 5.2.3, 5.2.4 and 5.2.5, for belt adjustment.

5.1.13 Lubricate grease fittings

Service Interval: Refer to chart.
a. Stop engine, wait for all moving parts to stop, and remove key.
b. Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose gun
grease.
Formula - 20071
Maintenance & Adjustment
31