Stopping Pto; Stopping Engine; Transporting A Unit - Gizmow Formula Operator's Manual

HOW TO AVOID THE HAZARD
Never operate the mower with the discharge deflector raised, removed, or altered
unless there is a grass collection system or mulch kit in place and working properly.
The PTO clutch push-pull switch engages the cutting blades. Be sure that all persons are
clear of mower deck and discharge area before engaging PTO.
IMPORTANT: Operator must be in seat before the PTO can be engaged and the Park Brake
MUST be dis-engaged.
Set throttle to half throttle position. Pull outward on the blade switch to the ROTATE
position. Accelerate to full throttle to begin mowing.
IMPORTANT: Never mow below 25mm (1in). This causes premature belt & blade wear
and increases the likelihood of striking foreign objects.
4.6.4

Stopping PTO

Set the throttle to the midway position. Push in on the switch to the STOP position
stopping the PTO.
4.6.5

Stopping Engine

Bring unit to a full stop. Disengage the PTO, move feet away from pedals so they do not
contact the pedals and engage parking brake.
Before stopping the engine, place the throttle control midway between the slow and fast
positions. Allow the engine to run a minimum of 15 seconds; then stop the engine.
Rotate ignition switch to OFF position. Remove the key to prevent children or other
unauthorised persons from starting engine.
Close fuel shut-off valve when machine will not be used for a few days, when transporting,
and when the unit is parked inside a building.
4.7 TRANSPORTING
4.7.1

Transporting a Unit

Use a heavy-duty trailer or truck to transport
the machine. Lock brake and block wheels.
Securely fasten the machine to the trailer or
truck with straps, chains, cable, or ropes. Use
the strapping down points provided. Be sure
that the trailer or truck has all necessary
lighting and marking as required by law.
Secure the trailer with a safety chain.
Formula - 20071
Operation
25