Deck Leveling - Gizmow Formula Operator's Manual

Maintenance & Adjustment
5.2.3

Deck Leveling

a. Position mower on a flat surface.
b. Stop engine, wait for all moving parts to stop, and remove key.
c. Check tyre pressure of all four (4) tyres. If needed, adjust to 16 psi (110 kPa).
d. Raise the deck to the 3" position as indicated on the height of cut indicator.
e. Position the blade so it points right to left. Measure the distance to the ground.
This is the height of cut. It should measure 3". If it does move on to the next
step.
If the height is not 3", the adjustment rods will have to be adjusted either up or down until
the height is at 3". Adjust both so that the deck is level in this step.
f. Measure from the top of the deck to the ground using a straight edge or tape
measure at points 1 and 2 as indicated below.
The initial measurements should be about the same. If not adjust as per step E.
36
Adjust this nut to
raise/lower deck
(2 places)
2
4
1
3
Formula - 20071