Seat; Hydrostatic Ground Drive System; Tyres And Wheels; Cutting Deck - Gizmow Formula Operator's Manual

Specifications
2.6

SEAT

2.6.1 Type: Standard seat: high back, foam padded (internal spring suspension).
2.6.2 Mounting: Seat is hinged to tilt up for access to hydraulic pumps, control cables
and other components. This can be held in tilted position with the prop rod. Adjustable
fore and aft seat track. Seat is also adjustable in position on the seat plate. 3 sets of hole
positions are provided.
2.6.3 Armrests: Padded flip-up armrests with height adjustment.
2.6.4 Seat Safety Switch: Incorporated into the safety interlock system.
2.7

HYDROSTATIC GROUND DRIVE SYSTEM

2.7.1 Hydrostatic Pumps: Two Hydro Gear 12cc variable displacement piston pumps.
2.7.2 Wheel Motors: Two Danfoss wheel drive motors with 1 1/4" tapered shafts.
2.7.3 Hydraulic Oil Type: Synthetic Mobil 1 15W-50.
2.7.4 Hydraulic Oil Capacity: 2.84 litres.
2.7.5 Hydraulic Filter: Replaceable cartridge type - P/N H18118: 10 micron
2.7.6 Speeds: 0 to 10.0 m.p.h. (16 kph) forward, 0 to 5.0 m.p.h. (5 kph) reverse.
2.7.7 Drive wheel release valves (located on the hydraulic pumps) allow machine to be
moved when the engine is not running.
2.8

TYRES AND WHEELS

2.8.1 Tyres: Size
Drive Tyres 24-12-12
Front Tyres 13-500-6
2.9

CUTTING DECK

2.9.1 Cutting Width:
61" DECK – 61"
2.9.2 Discharge: Rear or mulch.
2.9.3 Blade Size:
61" deck – (3) 21" blades
2.9.4 Blade Spindles: cast aluminum spindle with 1" I.D. bearings.
2.9.5 Deck Drive: Electric clutch mounted on horizontal engine shaft. Blades are driven
by two B section belts (w/self-tensioning idler) direct from the engine.
2.9.6 Deck: Full floating deck is attached to main frame. Deck design allows for
mulching or rear discharge.
2.9.7 Cutting Height Adjustment: an electric actuator controlled by a toggle switch on
the console is used to adjust the cutting height anywhere from 1" to 5". The position is
shown on an indicator located to the operators right above the rear of the deck. All
adjustments can be made while the operator remains seated. The cutting height may be
increased and additional ¾ of inch upwards (for a max cut height of 5 ¾" by moving the
three ¼" spacers between the blade and the spindle to above the spindle.
2.9.8 Mulching Kit: Optional.
14
Qty Tread Ply
2 AT101 4
2 Smooth 4
Inflation
16 psi
16 psi
Formula - 20071