Check Tyre Pressure; Service Hydraulic Oil - Gizmow Formula Operator's Manual

Assembly Instructions
NOTE: If the positive cable is also disconnected, connect the positive (red) cable to the
positive battery terminal first, then the negative (black) cable to the negative battery
terminal. Slip insulator boot over the positive terminal.
NOTE: If time does not permit charging the battery, or if charging equipment is not
available, connect the negative battery cables and run the vehicle continuously for 20 to
30 minutes to sufficiently charge the battery.
3.3

CHECK TYRE PRESSURE.

3.3.1 Check tyre pressure in caster and drive tyres. Proper inflation pressure for front
tyres is 16 psi (110 kPa). Proper inflation for drive tyres is 16 psi (110 kPa). Adjust if
necessary.
3.4 SERVICE ENGINE
Refer to Engine Owners Manual.
3.5

SERVICE HYDRAULIC OIL

The machine is shipped with hydraulic oil in the reservoir. Run the machine for
approximately 15 minutes to allow any extra air to purge out of the hydraulic system.
Check hydraulic reservoir and if necessary fill the reservoir to the appropriate level with
Mobil 1 15W-50 synthetic motor oil. Replace hydraulic reservoir cap and tighten until
snug. Do not over tighten.
NOTE: There are two lines on the dipstick. The oil level varies with the temperature of the
oil. The top line on the dipstick level shows the level of oil when it is at 225F (107C) - HOT.
The bottom line on the dipstick shows the level of the oil when it is at 75F (24C) - COLD.
Fill to the appropriate level depending upon the temperature of the oil in the machine. If
the oil is at room temperature (about 75 F (24C)), fill only to the COLD level.
18
Formula - 20071