Table of Contents
Advertisement
3
.
1
0
C
o
n
t
r
o
l
3
.
1
0
C
o
n
t
r
o
Diagram 3.19 is a screen shot of the Control Setting Menu. This menu is for setting up a connection
from the digital recorder to a computer to transfer instructions or information using the HyperTerminal
program in Windows. In the Control Setting Menu the following fields are defined as follows:
RS232:
S
e
t
u
p
M
e
n
u
l
S
e
t
u
p
M
e
n
u
RS232 Baud Rate: This field is to set the speed at which is used to transmit
instruction or information through the RS232 port on the DVR. There are six
different speeds, 1200 BPS, 2400 BPS, 4800 BPS, 9600 BPS, 19200 BPS, and
3840 BPS. The default setting from the factory is 9600 BPS. To change this,
simply use the Jog Dial on the DVR to make your selection.
RS232 Stop Bit: This field is to set the stop bit for the RS232 connection. There
are two different stop bits, 1 or 2. The default in the DVR is set to 1. To change
this, simply use the Jog Dial on the DVR to make your selection.
RS232 Parity: This field is to select the parity level at which you will be
connected. You can choose between None, Odd, or Even parity levels. Default is
set to none. To change this, simply use the Jog Dial on the DVR to make your
selection.
Diagram 3.19
53
Advertisement
Table of Contents
